Power Switch Monitoring System

However, current power grid monitoring and management system exists the following problems:

1. Column switch of the power distribution network has not monitoring equipment, which can not monitor sub-column switch open / close status information

2. Multi-grid distribution locates in remote areas, when the column switch tripping power outages due to failures and other reasons, the system can not determine accurate location of the failure, only rely workers to find it out one by one, which cause a lot of difficulties for timely repair and restoration of electricity

3. The system can not meet the monitoring and management needs of the different agencies of the power sector, low inefficiency

4. System network is not flexible, high maintenance cost, poor scalability

 System Architecture Requirements

1. The column switch points / closing status information real-time monitoring and alarm, can monitor current, voltage security, threshold, and etc

2. GPRS wireless networking, the system is simple and reliable, information transmission is stable and reliable

3. Meet multiple data centers communication, and send the column switch monitoring information to different departments

Four-Faith Solution

Features：

1. Column switch monitoring terminals connect to F2114 IP 4g modem via RS232/485 serial port, F2114 transfer the data to the center via GPRS network after receiving the information of monitoring terminals

2. F2114 supports up to five data center simultaneous transmission, can meet the needs of different department in the electricity sector

3. Transparent transmission mechanism to send the information to the center without any change, in order not to cause package data errors

4. Using GPRS communication, networking is simple and effective, stable and reliable data transmission

Four-Faith Solution and Feature：

1. Taking the initiative to report, F2114 initiative to send the monitoring information and alarm to the center, to real time upgrade on-off monitoring and alarm of grid column switch

2. Mature GPRS communication network, networking is simple and effective, stable and reliable data transmission

3. F2114 has 5 channel I / O ports, five digital input and output, not only to monitor the column switch information, but also to monitor other information, such as current, voltage threshold, the system is flexible and scalable

4. F2114 supports main and side dual center backup transmission, and communication is up to five data centers, simultaneous transfer the information at the first time of distribution network to the relevant departments to enhance the capacity of the grid joint management

5. F2114 adapts industrial-grade transmission communication module, is able to adapt to the grid column switch distribution in remote and harsh environment conditions to ensure stability and reliability of the system

Appendix：Four-Faith F2114 GPRS IP Modem Features

    ◆ High-performance industrial-grade wireless module and 32 bytes communication processor
    ◆ Low power consumption design, the minimum power consumption as low as 1 mA
    ◆ Support hardware and software WDT, support auto recovery mechanism, including online detect, auto redial when offline to make it always online
    ◆ Convenient system configuration and maintenance interface
    ◆ Support the main and side dual data center backup transmission and simultaneous transmission of multiple data centers (five data centers)
    ◆ Support APN/VPDN
    ◆ Support 5 I/O channels, compatible 2 pulse wave output channels, 2 analog inputs and one pulse input counter.
    ◆ Support access to the center of the domain names and IP addresses
    ◆ Embedded standard TCP/IP protocol stack, support transparent data transmission
    ◆ Standard and easy-to-use, power-on to enter data transfer state